1/16/2024 0 Comments Led projector retrofit![]() ![]() No scratches but a couple flakes of chrome came off when I removed this tape on the reflectors! Best would be to use plastic cling wrap and tape it with electrical tape on the back side of the reflectors only!Ĭut the hole! Take your time and test fit the projector often! I made the mistake of mask taping the reflector. There is not a lot to show here except that you should use the lines on the projector to keep the hole centered and so that both right and left projectors mount in the same position on the reflector. Use a dremel tool with cutting disk to cut the hole out for the projector: The best idea here is to work slow, cut a small amount first and then start fitting the projector bowl in from the front side and enlarge the hole as needed to center the projector and allow it to seat all the way to the bolt holes on the lens holder. Remove the bulb holder wire and screw and remove the single screw that holds the H1 low beam bulb shield and remove the bulb shields. Now comes mounting the projectors (or retrofitting). Then use a large flat head screwdriver to pry the ball joint out of its socket. Loosen (counter clockwise) the adjustment screws in the headlight alternately until the little ball joint has tension on it. Cut the sealant immediately with a sharp knife as it comes apart. Remove them and then using a flat head screwdriver, pop the clips loose as you pry the lens away from the black housing and the sealant should stretch. Take your bulbs out FIRST! Use the oven method to remove the headlight lenses: Preheat oven to 200 degrees, then turn it off, put a cotton towel in the oven and set the headlights (one at a time) on the towel. Unplug the headlight harnesses and remove the headlights. Unbolt the headlights! There are 3 stainless bolts:.There are 2 clips above the side markers that must pop straight out to come off and then it clips under the headlights, pull forward after you get the side clips free and off it comes! Now store it somewhere safe inside! Use two people and slowly work the bumper cover off.Remove the two phillips-head bolts (8mm) that hold the bumper cover to the wheel well (you may have to pull the black plastic wheel well cover up some to get to this screw).Raise the front of the car enough to get under it and take the 6 bolts out that hold the bumper cover from underneath (all bolts are 10mm, use a socket ratcheting wrench).Remove the honeycomb grill (2 bolts and a couple plastic clips).Rated Power: High/Low Beam 55W/Piece, High Beam+Low Beam+Laser Lights 70W/PCĬooling Fans: High speed cooling fan and aluminum heat dissipation module are combined to provide high efficiency heat dissipation.40% cooler than others.ġ piece or 2 pcs 3.5th Gen Prelude Headlamp Retrofit using 2.5" Valeo (Audi A4) H7 or D2S projectors (Retrofit done by JLUDE - originally posted on ): Latest xkm7 hyperboloid convex glasses lens.The low beam lights will go through the big lens and the high beam and laser lights will go through both the small and big lens, making the lights output 50% brighter than standard BI-LED kit. Structure: Each projector lens is equipped with 2 reflectors + 7 high bright LED chips + 1 laser tube.Įnsure most light is concentrated and the luminous efficiency is greatly improved. The xkm7 laser spotlights can reach the top of a 30 floors building,offers you a bright vision ahead and safe driving experience. ![]() Latest BI-LED Projector Lens xkm7 headlight design which combines the latest technology- LASER headlights and Hyperboloid glasses lens, making the LED lights really strong and reach up to 700 meters distance. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |